Apple Xserve Intel (Late 2006) DIY Procedure for Processor - Manual (Page 7)

Xserve (Late 2006) Processor Replacement Instructions
Installing the Replacement Processor
Note: You will need to apply new thermal grease to the top of the replacement processor before
installing it on the logic board. Steps 1 and 2 below explain how to apply the thermal grease.
Using the syringe of thermal grease that came with the replacement processor, apply the
entire contents of the syringe (approximately 4.5 cc) to the top surface of the processor.
Important: Be sure not to get grease anywhere on the processor other than the very top, flat
surface that directly contacts the heat sink.
Use the edge of the package that the alcohol wipe came in as a spatula to spread the
thermal grease evenly over the entire top surface of the processor. Scrape off any excess
grease with the package edge, then discard the package.
1.
2.