2GIG KEY2-345 - Manual (Page 2)

Testing
1 From the Installer Toolbox, select walk test.
2 To test the disarm button, hold the button down for 2 seconds. This disarms the Control
Panel as well as the doors, windows, and motion detectors.
3 To test the away button, hold the button down for 2 seconds. This arms the Control Panel
as well as the doors and windows (in Away mode).
4 To test the stay button, hold the button down for 2 seconds. This arms the Control Panel as
well as the doors and windows (in Stay mode).
5 To test the Auxiliary button (if previously programmed, this button can trigger a pre‐
selected output).
6 To test the Away and Disarm buttons (if the emergency key was programmed in step 6 above),
pressing both the Away and Disarm buttons at the same time for 5 seconds sends one of four
types of emergency signals:
• (1) silent panic
• (2) audible alarm
• (3) silent panic
• (4) fire
7 Exit the Installer Toolbox.
Inserting and Replacing Batteries
WARNING: The polarity of the battery must be observed, as shown. Improper handling of lithium batteries may
result in heat generation, explosion or fire, resulting in personal injuries. Replace only with the same or equivalent
type of battery as recommended by the manufacturer (see Specifications). Batteries must not be recharged,
disassembled or disposed of in fire. Disposal of used batteries must be made in accordance with the waste
recovery and recycling regulations in your area. Keep Away From Small Children. If batteries are swallowed,
promptly seek medical attention.
California Only: This Perchlorate warning applies only to Manganese Dioxide Lithium cells sold or distributed ONLY in /
California, U.S.A. Perchlorate Material‐special handling may apply. See dtsc.ca.gov/hazardouswaste/perchlorate.
Specifications
FCC and Industry Canada Regulatory information
This device complies with Part 15 of the FCC's Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This product complies with FCC radiation exposure limits for an uncontrolled environment. Avoid operating this product at a distance
less than 20 cm from the user.
Caution: Any changed or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
LIMITED WARRANTY
This 2GIG Technologies product is warranted against defects in material and workmanship for 2 years. This warranty extends only to
wholesale customers who buy direct from 2GIG Technologies or through 2GIG Technologies’ normal distribution channels. 2GIG
Technologies does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the
dealer’s warranty, if any.
There are no obligations or liabilities on the part of 2GIG Technologies for consequential damages arising out of or in connection
with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of
removal, installation, or reinstallation. All implied warranties for functionality, are valid only until the warranty expires. This 2GIG
Technologies Warranty is in lieu of all other warranties expressed or implied.
For technical support in the USA and Canada:
855-2GIG-TECH (855-244-4832)
For technical support outside of the USA and Canada:
Contact your regional distributor
Visit dealer.2gig.com for a list of distributors in your region.
PN: 187-1084 Rev C
2GIG Copyright © 2013. All rights reserved.
Wireless Signal Range 350 ft, open air, with 2GIG Wireless Control Panel
Code Outputs Arm; Disarm; Panic; Relay Control
Transmitter Frequency 345.000 MHz (crystal controlled)
Transmitter Frequency Tolerance ±15kHz
Transmitter Bandwidth 24kHz
Modulation Type Amplitude Shift Keying‐‐On/Off Keying (ASK‐OOK)
Unique ID Codes Over one million different code combinations
Supervisory Interval 70 minutes
Peak Field Strength Typical 40,000 uV/m at 3m
Dimensions (LxWxH) 1.23 x2.26 x 0.45 in. (3.12 x 5.74 x 1.14 cm) typical
Weight (including battery and magnet) 0.65 oz. (18.4 g)
Housing Material ABS plastic
Color White
Operating Temperature Limits 32° to 120° F (0° to 49° C)
Relative Humidity 5‐95% Non‐Condensing
Battery (installed with pull tab) One Panasonic CR2025, or equivalent Lithium batteries
Included Accessories Key ring