Rock-Slide Engineering PATRIOT SERIES – REAR BUMPER - Manual (Page 2)

PATRIOT REAR BUMPER INSTALLATION
License Plate Lights Spare Release Lock
Back Up Sensors
Bolt Placement
1. Remove factory bumper.
2. Install Anzo lights using manufacturers hardware/brackets before mounting the R-SE Patriot.
3. Connect spare release lock into its respective hole.
4. Connect license plate lights into their respective holes.
5. Connect back up sensors into their respective holes.
6. Mount the R-SE Patriot into its proposed position making sure its level and even on both sides.
a. You might want help doing this to position R-SE Patriot evenly
7. Using 1/2’’ wrench/socket secure the R-SE Patriot onto the Raptor frame.
a. 6 5/16’’bolts, 12 3/8’’ washers, 6 5/16’’ nuts
b. You will be using 1 bolt, 2 washers, and 1 nut per mount
i. Sequence= bolt - washer - bumper - washer – nut
c. We recommend fastening top 4 bolts first, then bottom 2
8. Put final tightening on all bolts to make sure R-SE Patriot rear bumper is fully secure.
Thank you for choosing Rock-Slide Engineering products. We value your business and welcome your
feedback/suggestions. If you have any concerns please contact us directly @ 435-752-4580. We are
here to help you!