Rock-Slide Engineering JK – VACUUM PUMP RELOCATION - Manual (Page 2)

Installation Instruction RSEI 118
Installing the Relocation Bracket
1. Use a 10mm wrench to remove both of the bolts
2. Use the two factory bolts to mount the bracket to the vehicle near the front of the hood
on the driver’s side of the vehicle.
Installation of Vacuum Pump
1. Cut and extend the vacuum pump wiring harness.
2. With wire cutters, remove the section of the wire loom leaving 2” of wire after the
connector.
3. Using the 4 connectors and wire in the kit, strip and connect the wires using a crimping
tool.
4. Feed the wires up the engine compartment to where the bracket is located.
5. Feed and reconnect the vacuum connector clip and one-way valve onto the vacuum
canister
6. Connect the electrical wiring and position the canister into the bracket
7. Bolt the canister to the bracket with the bolts provided. Position the wiring to not
interfere with any other functions.
8. Use Zip ties to secure the wiring and vacuum hoses so they are not in the way of other
components under the hood and so they will not come loose.
Thank you for choosing Rock-Slide Engineering products. We value your business and welcome your
feedback/suggestions. If you have any concerns please contact us directly @ 435-752-4580. We are
here to help you!