Rock-Slide Engineering R-SE JK BOMBSHELL KIT - Manual (Page 2)

Installation Instruction RSEI 117
place. Be sure to distribute the holes appropriately to receive the maximum
strength.
3. Plug weld the inner sleeve kit into place
4. Weld the end of the inner sleeve to the shaft on the end.
5. Remove any excess weld if needed
Installation of the outer sleeve kit
1. First step is to clean up the axle. Place the Bombshell kit around the axle
and hold in place while you scribe around the perimeter of the shell. Use
these marks to clean up the axle with a flapper disc (or similar) in order to
obtain a clean strong weld.
2. Once you have it cleaned up place the Bombshell kit around the axle
housing and clamp in place.
3. Proceed by welding the kit to the housing. Weld all circular edges fully in
order to gain the strength advantage of the kit. These include the ends of
the pieces and any cutout that wraps around a bracket. On the straight or
axial edges, weld at least 50% of the length in 1.5”-2” sections. These edges
are not as critical to gain the strength. Fully weld the slots between the
upper and long lower piece.
Installation of the knuckle gussets
1. Weld the knuckle gussets in place as shown in the picture below.
Thank you for choosing Rock-Slide Engineering products. We value your business and welcome your
feedback/suggestions. If you have any concerns please contact us directly @ 435-752-4580. We are
here to help you!