Rock-Slide Engineering Rigid Rack - Manual (Page 2)

Installation Instruction RSEI 127
Rigid Rack Installation
1. The Rigid Rack is specifically designed to attach to the Tire Arm Carrier of the Rock-
Slide Engineering Rear Bumper with Tire Carrier. It could however be mounted to any
2” wide, 45 degree angle swing arm carrier
2. Set the Rigid Rack on the Tire Arm Carrier in the desired position. Ideal location is
close to the spare tire without touching the spare
3. Run the U bolts from the bottom of the tire carrier arm up to the holes on the Rigid
Rack. You may have to pull the U bolts apart to make the wide enough to fit into the
holes
4. Attach the both U Bolts with the washer and nut. Alternate tightening both sides of
the U bolt to ensure it tightens evenly
5. The Rigid Rack has mounting holes for a variety of attachments. Possibilities include:
a. Rock-Slide Engineering Jack and Shovel Mount (part # AC-HIS-100, comes with
two brackets for a top and bottom mounting security)
b. Roto-Pax can system
U Bolts installed from
the bottom up