Rock-Slide Engineering Step Slider Door Delete Kit - Manual (Page 3)

INSTALLATION INSTRUCTION RSEI 132
4. Remove plastic trim piece in order to install button
5. Drill hole for the button in trim piece. Recommend using a step-up drill bit to get the
tightest fit. Drill the hole with the step-up bit until the button will push into the hole
with resistance. If not step-up bit is available, use a 7/8” drill bit for the button
6. Push them button into the hole from the top down. The button will hold itself in the
hole
7. Unplug the door sensor from the wiring harness
8. Plug the door delete button plug into the into the wiring harness and the door sensor
plug into the door delete plug
Plug into wiring harness Plug sensor here