Rock-Slide Engineering RIGID SERIES FRONT BUMPER - Manual (Page 3)

INSTALLATION INSTRUCTION RSEI 100
RIGID SERIES FRONT BUMPER INSTALLATION
**WARNING: MUST READ**
DO NOT REMOVE FRONT BUMPER UNTIL YOU HAVE DISCONNECTED THE LIGHT WIRE
HARNESS AND LIGHTS. FAILURE TO DO SO CAN RUIN YOUR TRACTION CONTROL SYSTEM.
1. After you have disconnected the light wire harness and lights, remove the
stock plastic bumper and skid plate.
Installing with winch
1. Mount the winch on the bumper before mounting the bumper onto the Jeep.
a. Use the hardware provided with the winch to secure it to the bumper
2. If optional Bull Bar is included, mount Bull Bar to bumper prior to installing.
a. Mount the R-SE Rigid Series Bull Bar using the following:
4 7/16’’x1’’ bolts, 4 7/16’’ washers
3. Secure the R-SE Rigid Series bumper using the following.
a. 8 7/16’’x1’’ bolts, 8 7/16’’ nuts, 16 7/16’’ washers
b. You will be using 2 washers per bolt and nut
4. Secure the winch plate by placing the following through the frame into the
winch plate.
Failure to secure the winch plate to the frame with the bolts provided will
cause winch plate to twist and cause your winch to malfunction.
a. 2 4.5’’x7/16’’ bolts, 2 7/16’’ nuts, 4 7/16’’ washers
*Aluminum products will use a 3/8” bolt and washer to mount Bull Bar to bumper.
Included in the hardware kit.