beautypg.com

GFB DV+ (part T9352) User Manual

Page 2

background image

Installation Instructions for GFB DV+ TMS valve (part # T9352)


Locate factory diverter valve. It will be mounted directly on the turbo compressor cover, either above or
below the plastic intake pipe as shown below:











Remove the intake duct to gain access to the diverter
valve and the 3 bolts holding it to the turbo. Unclip
the wiring connector from the top of the solenoid
coil – note there is a small locking tab that needs to
be unclipped as you pull on the connector

Unscrew the 3 mounting bolts and remove the
diverter valve from the car



Pull on the plastic diaphragm shroud, the whole assembly will
pop off leaving the bare solenoid coil. Keep the yellow o-ring



Install the GFB parts onto the solenoid as shown below, using a little engine oil on the outside of the
piston. Make sure to use the GFB supplied spring inside the solenoid coil – the only factory parts you re-
use are the solenoid coil and the yellow o-ring









Fit the valve/solenoid assembly to the car in the factory location using the supplied longer bolts, and re-
connect the wiring loom