PureFlow AirDog FP-150 - Dodge Cummins 2005-2013 - Manual (Page 15)

15
PureFlow AirDog
AirDog
®
FP-100 & FP-150 Dodge 2005- Present
Section 5-D Fuel Lines
INSTALLING THE IN-TANK FUEL PUMP BYPASS
SUCTION TUBE!
NOTE: The AirDog
®
installation kit includes a Suction Tube to by pass the
“in-tank fuel pump on the 2005 - Present Dodge .
To install the suction tube it is necessary to either drop the fuel tank or to lift the truck bed.
NOTE: Should you choose to drop the fuel tank, support the tank as it is when it is installed
on the truck. If you let it rest flat on the floor, the tank may squash out and the suction tube
will be too short after the tank is re-installed in the truck. The suction tube, being cut too
short may suck air as the fuel drops below ¼ tank level.
NOTE: Should you choose to pull the pickup bed to access the tank. Be sure to disconnect
the tail light wires, fuel tank filler tube, and any other accessories or components that may be
secured to the frame and bed.
When Dropping the Tank, Always Remember Safety First!
Figure 25
Figure 36
Figure 27
If you choose to remove the bed, properly support the truck bed to prevent
serious injury or death!
Figure 28 Figure 29