Fast & Fluid Giotto Compact - Manual (Page 13)

Fast & Fluid Management Srl
A Unit of IDEX Corporation
_______________________________________________________________________________________________
1155007C-it,en,fr.doc – 16/10/2003 13
3.- ASSEMBLY
Identify the right side (2) and the left one (3).
Put the superior plate (1) in the corret assembly position.
Assemble using screws type “C”.
Assemble on the sides (2) and (3) the back panel (4) using screws type “B”.
Assemble the guide (5) and (6) with the angulars (7) on the side (2) using screws type “D”.
DIAGRAM 1
Lower the turning table (6) onto the motor shaft pre-assembled on the support plane (1) and
block it using washer and screw (DIAGRAM 2).
Assemble on the turning table (6) complete canisters (8), inserting them in their place . Block
each canister on the turning table (6), from below, using the screws supplied and keeping free
hole (7). (DETAIL 1) - (DIAGRAM 2)