ARB 3915030 - Manual (Page 22)

Last Rev Date: 29/10/2008 Page 22 of 24 Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BAR ON VEHICLE
54. Wire up indicators and parking lamps.
Note:
Wire configuration of supplied indicator looms;
Black = ground
Green = indicator (amber)
Red = run lamp (clear)
55. Use supplied scotch locks for the electrical
connections then secure wiring with cable ties
when complete.
56. Wire up P# 6821201 ARB fog lamps if fitted.
NOTE: For vehicles without factory fog lamp loom,
use ARB Loom MD02 plus switch. Supplied tails
can be joined to OE loom
77. Using square file, increase slot length in 2 x
existing holes in sump guard (those pitched
570mm apart) to a size of 12.3mm A/F.
78. Fit two M8 cage nuts to slots in sump guard
(NOTE: nut body above panel as shown).
79. Fit stone tray using 4 x M8 bolts and washer
sets at front and 2 x M8 bolts, washers and
into fitted M8 cage nuts at two locations into
existing sump guard front section as shown.
72. Trim fender liner if required. Tuck behind
wing return.
73. If required secure with cable ties through
holes in bulkhead.
View from
underneath
View from top
Running
lamp wiring
Indicator
lamp wiring