ARB 3915030 - Manual (Page 17)

Last Rev Date: 29/10/2008 Page 17 of 24 Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING BUFFERS WITH FRAME
56. Fix the frame to the hinge brackets using 4 x
sets M10 x 30 Cap Screws, flat and spring
washers
57. Ensure that the frame is centred on the
brackets and bar assembly
58. Tighten the cap screws to recommended
torque
59. Slide the buffers down over the frame and
secure using M6 flange nuts on the four lower
buffer studs on each buffer and M6 nyloc nuts
with large M6 flat washers on the two studs
located on top face.
CAUTION: Do not over tighten nuts as damage
to buffer can result
NOTE: The latching assembly is only
fitted to RHS of the bumper
60. Fit the slam latch assembly to RHS (inboard
side of upright) secure using ¼ UNC x 1”
bolts, flat and spring washers. Lever arm is
to rear of bumper.
61. Tighten firmly, to 14Nm (11lbft).
View from
inside bumper