ARB 3448200 - Manual (Page 3)

06-01-2005 Page 3 of 7 3782877
ASSEMBLY SEQUENCE FOR BULL BAR INSTALLATION.
1. Remove bumper bar from the vehicle.
2. Fit the indicators into bar.
3. Fit numberplate bracket to bull bar using 6mm
hardware if bar is going to have a winch fitted.
4. Fit buffers to bull bar using 6mm flange nuts
supplied in buffer kit.
NOTE: DO NOT OVER-TIGHTEN.
If fitting XP 9.5 winch, continue to step 5,
otherwise, jump to step 12.
5. If fitting the XP 9.5 winch, remove the cover from
the control box.
6. Remove the two cap screws, nuts and spacer
washers that hold the four solenoids in place.