ARB 3450120 - Manual (Page 8)

29/8/05 Page 8 of 12 3783172
23. To fit winch into bar you must pack winch
up on a bench to enable you to lower bar down
on winch.
24. Line up top holes first and secure using
3/8” hardware (1 ½”” x 3/8”bolts) flat and
spring washers.
25. Place roller fairlead over lower holes and
again secure using 3/8” hardware (1 ¾”x 3/8”
bolts) flat and spring washers. When all bolts
are fitted tighten firmly.
26. Fit control box to control box bracket
using original ¼” nuts from control box and
connect power cables to winch motor as per
winch instructions.
27. Cable tie power cables to bar keeping
cables clear from all moving parts.
Optional driving light fitted.
( Viewed from rear of bar )
Fasten control box earth to
winch tie rods.