Getting started, Connecting the barcode scanner (optional) – Fluid Management 1500HS Accutinter User Manual
Page 17

Fluid Management Customer Service 1 . 800 . 462 . 2466
Accutinter 1500 | 15
4
Connect the scanner cable to
the purple keyboard connector
on the back of the computer
where the keyboard symbol
is marked.
The barcode scanner must be connected to the computer and keyboard. The barcode scanner is
pre-programmed by Fluid Management. After the barcode scanner is connected, the scanner must be
enabled to be compatible with ColorPro. The original packaging from the vendor includes the barcode
scanner, the cable, and a quick start guide.
Follow these steps to install the barcode scanner:
a. Unpack the barcode scanner.
b. Make sure the barcode scanner and the
cable are included.
c. Turn on the computer.
1
3
Connect the scanner cable to the keyboard
cable from the Accutinter1500.
NOTE! If the keyboard cable is a USB, add
an adapter and connect the two cables.
Plug the interface cable modular cord into the
port in the bottom of the scanner’s handle.
2
Getting Started
Connecting the barcode scanner (optional)