Philips VR674CAT - Manual (Page 45)

Automatic Operation Features 45
The following playback features will always operate.
Automatic Playback
When you put a tape in the VCR, the power will come on auto-
matically. If the tape’s record tab is missing, playback will begin.
If you have set a timer recording, the power will not come on
automatically when you insert a tape with the record tab intact.
If you have set a timer recording and the VCR power is off, the
VCR will eject the tape if the record tab is missing.
Automatic Rewind, Eject, Off
When you play, fast forward, or record a tape to its end, the VCR
will rewind the tape, stop, eject the tape, and turn itself off.
If the real-time counter memory is set, the VCR will only rewind
the tape to the point at which you set the counter to zero, then
stop. The VCR will not eject the tape automatically or shut itself
off.
Tape Eject
You can eject a tape with the VCR power on or off, but the VCR
power cord must be plugged in. If you have set a timer recording,
you can eject a tape only if the VCR power is on. Make sure you
insert a tape and turn off the VCR power for the timer recording.
Automatic Tracking Adjustment
The VCR adjusts tracking automatically to give you the best possi-
ble picture quality. With some recordings, however, you may get a
better picture using the manual tracking controls (see below).
Manual Tracking
To manually adjust the tracking during playback and slow motion
playback, press the CHANNEL o/p buttons on the front of the
VCR or the TRACKING o/p buttons on the remote control.
Tracking will return to Automatic Tracking Adjustment when you
press the STOP/p button, insert a tape, or press the PLAY but-
ton on the front of the VCR.
To remove vertical jitter in a Still picture, press the CHANNEL
o
/p buttons on the VCR or the TRACKING o/p buttons on
the remote control.
Before
Tracking
Adjustment After
Tracking
Adjustment