Philips BDH5011-74B - Manual (Page 24)

8.2 Selecting Signal Source
Using Front Panel or Remote Control
1. Press the INPUT key on the front panel or
the INPUT SELECT key on the remote
control.
2. Pressing the INPUT key will cycle the display
through all available input signal sources in
the following order:
Using Direct Input Selection Keys
1. If you prefer not to cycle through all
available inputs, you can use the Direct Input
Selection keys located at the bottom of the
remote control.
2. Simply select the input that you would like
to switch to and press the Direct Input
Selection key for that input.
Notes:
• Some of the Direct Input Selection keys will
not be applicable for this display.
For AV mode, use AV1.
For S-Video, use AV2.
DIRECT INPUT
SELECTING KEYS
INPUT SELECT
(Toggle)
AV S-VIDEO COMPONENT1
RGB COMPONENT2 DVI
24
User Manual BDH5011