Philips Fidelio SoundSphere docking speakers DS9800W with AirPlay with 30-pin connector for iPod-iPhone-iPad 100W User Manual

Page 13

4 Connect to

your home Wi-

Fi network for

AirPlay

To connect DS9800W to your existing home
Wi-Fi network, you need to apply your home
Wi-Fi setting to DS9800W.
You can do this in two ways (depending on
which type of Wi-Fi router you use):

$XWRPDWLFDOO\LI\RXU:L)LURXWHULV

WPS (Wi-Fi Protected Setup)-enabled
and supports PBC (Push Button
Connection) (see 'Scenario 1: Connect
to a WPS router' on page 13)

Manually - if your Wi-Fi router does

not support WPS (see 'Scenario 2:
Connect to a non-WPS router' on
page 14)

Once connected successfully, DS9800W will
remember your home Wi-Fi settings. Then
\RXFDQHQMR\$LU3OD\ZKHQHYHU'6:LV
powered on and connected to your home Wi-
Fi network automatically.
Before connection of DS9800W to you home
Wi-Fi network, check the points below.

Make sure that your Wi-Fi router is
powered on and working properly.

Make sure that DS9800W has been
powered on and booted up successfully
(see 'Turn DS9800W on' on page 11).

Identify the type of your Wi-Fi router (see
the user manual of your Wi-Fi router for
details).

Scenario 1: Connect to a

WPS router

Note

Before you press any button on DS9800W, make sure
that DS9800W has been booted up successfully (see
'Turn DS9800W on' on page 11).

Press the WPS button on your home Wi-Fi
router.

Shortly after step 1, press Wi-Fi SETUP on
the back of the main speaker.

The LED indicator blinks red, yellow
and green alternately.

Within 2 minutes, the LED indicator
stops blinking and stays green, and the
unit beeps.

DS9800W is connected to your home
Wi-Fi network successfully.

WPS