Philips Fidelio SoundSphere docking speakers DS9800W with AirPlay with 30-pin connector for iPod-iPhone-iPad 100W - Manual (Page 12)

12 EN
» $IWHUERRWXSLIQR:L)LFRQQHFWLRQ
has been set up for DS9800W, the
LED indicator starts to blink green
slowly.
‡ To switch the unit to standby mode, press .
‡ To switch the unit on from standby mode,
press again.
Prepare the remote control
Caution
‡ Risk of explosion! Keep batteries away from heat,
VXQVKLQHRUÀUH1HYHUGLVFDUGEDWWHULHVLQÀUH
‡ Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
)RUÀUVWWLPHXVH
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
‡ Before pressing any function button on the remote
FRQWUROÀUVWVHOHFWWKHFRUUHFWVRXUFHZLWKWKHUHPRWH
control instead of the main unit.
‡ If you are not going to use the remote control for a
long time, remove the battery.