Philips HTS3564-F7 - Manual (Page 29)

18 EN
3
Select a picture, and then press (Play) to
start the slideshow.
4
Press to stop slideshow.
5
Press again to stop music.
Note
• Make sure that the picture and audio formats are
supported by your home theater (see 'File formats' on
page 26).
Radio
Listen to FM radio on your home theater, and
store up to 40 radio stations.
Note
• AM and digital radio are not supported.
• If no stereo signal is detected, or if fewer than five
stations are found, you are prompted to install the
radio stations again.
1
Extend the FM antenna at the back of your
home theater and place it away from the
TV or other sources of radiation.
2
Press RADIO.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. press (Play).
3
Use the remote control to listen or to
change radio stations.
Button Action
/
or
Alphanumeric
buttons
Select a preset radio station.
Navigation
buttons
Left/Right: Search for a radio
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation
of radio stations.
BACK Press and hold to erase the
preset radio station.
OPTIONS Manual:
1) Press OPTIONS.
2) Press / to select
your preset. 3) Press
OPTIONS again to store the
radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE Toggle between the stereo
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz. Switching
the tuning grid erases all preset radio stations.
1
Press RADIO.
2
Press .
3
Press and hold (Play) to toggle between
50 kHz or 100 kHz.
MP3 player
Connect a MP3 player to play audio files.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the MUSIC
iLINK connector on your home theater.
HTS3564_F7_UM_V1.0.indb 18 2012/7/20 11:09:13