Philips MC145C-37 User Manual

Page 6

Supplied accessories

– 2 speaker boxes
– Remote control
– 2 batteries for the remote control, size AAA
– AM/MW frame aerial
– FM aerial wire
– Mains lead

General maintenance

Do not expose the unit, batteries
or CDs to humidity, rain, sand or
excessive heat (caused by heating
equipment or direct sunlight).

You can clean the unit with a
soft, slightly dampened lint-free
cloth. Do not use any cleaning
agents as they may have a
corrosive effect.

Environmental information

All redundant packing material has been omitted. We have
done our utmost to make the packaging easily separable into
three mono materials: cardboard (box), polystyrene foam
(buffer) and polyethylene (bags, protective foam sheet).

Your unit consists of materials which can be recycled if
disassembled by a specialized company. Please observe the
local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.

Batteries for the remote control

• Open the battery compartment of the remote control and

insert 2 batteries, type AAA, R03 or UM-4 (preferably
alkaline).

Remove batteries if they are flat or if the unit is not going
to be used for a long time.

Batteries contain chemical substances, so they
should be disposed of properly.

Speaker connections

The speaker terminals are click-fit connectors. Use them as
shown below.

• Connect the unmarked wire to the red terminal and the

marked (black) wire to the black terminal.

Mains

The type plate is located on the back of the unit.

1 Check whether the mains voltage as shown on the type

plate corresponds to your local mains voltage. If it does
not, consult your dealer or service organisation.

2 Connect the mains cable to the AC MAINS inlet and the

wall socket. This switches on the mains supply.

Safety information

To disconnect the unit from the mains completely, remove
the mains plug from the wall socket.

Place the unit on a solid surface. Make sure there is
sufficient space around the unit to prevent overheating.

This set complies with the radio interference
requirements of the European Community.

For users in the U.K.: please follow the instructions
on page 2.

English

GENERAL INFORMATION

REMOTE CONTROL

POWER SUPPLY

8 mm