Bosch WFMC6401UC - Manual (Page 19)

19
Unbalanced load detection system
The automatic unbalanced load
detection system spins the laundry
several times to ensure even
distribution.
If the wash load is unevenly distributed,
it will not spin (for safety reasons) or the
final spin speed is reduced.
In the wool program the appliance will
attempt to start the spin cycle only
twice in order to prevent shrinking.
Displayed Time
Due to these and other characteristics
of the controls the actual cycle time will
vary.
When a program has been selected,
the expected cycle time is displayed.
The following will effect the displayed
time:
- Load size
- Repeated spin attempts to evenly
distributed load
- Additional rinse cycles if excessive
foam occurs
- Water pressure is too low
- Selection of additional options,
e.g. Rinse plus"
i You may notice these effects
(more or less time) changing the
displayed time when they occur in
the cycle. If no options are
selected and these effects do not
occur, the time indicated will be
time that the cycle will finish.
Washing with
Standard Settings
The specified standard settings are
optimized for the selected program.
If you do not want to change these
standard settings:
q Turn on the water taps.
q Turn the program selector to the
desired program.
q Load the washing machine and
close the door.
The Start/Pause indicator light
flashes (red).
q If necessary, press the button(s) for
additional option(s).
The indicator light of the selected
button is lit (red).
i If an incorrect combination was
inadvertently selected, the
indicator light of the selected
button is turned off and a signal is
emitted.
q Press the Start/Pause button.
The indicator light is lit (red).
The program starts.
i Each program step is indicated in
the display field.
Washing with individual settings is
described on the next page.