Philips HTS3530-05 - Manual (Page 15)

13
Change general settings
1
Press SETUP.
2
Select [General Setup], then press OK.
3
Select and adjust the following settings:
• [Disc Lock] : Restricts play to disc.
Password (PIN code) is required to
unlock the disc before play.
• [Display Dim] : Changes the brightness
of the display panel.
• [OSD Language] : Selects the on-
screen display menu language.
• [Screen Saver] : Enables or disables
screen saver mode. If enabled, the
screen enters idle mode after 10
minutes of inactivity (for example, in
pause or stop mode).
• [Sleep Timer] : Sets a sleep timer to
switch the home theatre to standby
after a specific time.
• [Auto Standby] : Enables or disables
auto standby. If enabled, the home
theatre switches to standby after 30
minutes of inactivity (for example, in
pause or stop mode).
• [DivX® VOD Code] : Displays the
DivX VOD registration code for the
home theatre.
4
Press OK to confirm your choice.
Note
• Before you purchase DivX videos and play
them on the home theatre, register the home
theatre on www.divx.com using the DivX
VOD code.
Change audio settings
1
Press SETUP.
2
Select [Audio Setup], then press OK.
3
Select and adjust the following settings:
• [Speakers Volume] : Sets the volume
of each speaker to obtain the ideal
audio balance.
• [Speakers Delay] : Sets the delay time
for centre and rear speakers to obtain
an equal audio transmission from all
the speakers.
6 Change settings
This section helps you to change the settings of
your home theatre.
Caution
• Most of the settings are already configured
with the best value for the home theatre.
Unless you have a specific reason to change a
setting, it is best to leave it at the default value.
Access the setup menu
1
Press SETUP.
» The following menu appears.
Symbol Description
[General Setup]
[Audio Setup]
[Video Setup]
[Preference Setup]
2
Select a setup menu, then press OK.
See the following sections for information
about how to change the settings of your
home theatre.
3
Press BACK to return to the previous
menu, or press SETUP to exit.
Note
• You cannot change a setting that is grayed out.
English
EN