Philips Micro Hi-Fi System - Manual (Page 19)

19
Set up wireless connection manually
1
In standby mode, press and hold SOURCE
on the main unit for 3 seconds.
The blue and green indicators on the
subwoofer fl ash alternately.
[PAIRING] (pairing) fl ashes.
2
Press and hold PAIR on the subwoofer for
3 seconds.
[PAIR OK] (pair OK) and are
displayed and the blue indicators on
the subwoofer lights up.
3
Turn on the main unit again.
Note
If the wireless connection fails again, check whether
there is any confl ict or strong interference (for example,
interference from other electronic devices) around
your location. After removal of the confl ict or strong
interference, repeat the above procedures. •
»
»
»
4
Press SET TIME/PROG to confi rm the
clock setting.
Turn on
1
Press .
The soundbar switches to the last
selected source.
2
Wait for automatic setup of wireless
connection between the main unit and
subwoofer.
[PAIRING] (pairing) fl ashes.
If the connection succeeds, [PAIR OK]
(pair OK) and
are displayed and
the blue indicator on the subwoofer
lights up.
If the connection fails, [PAIR FAIL]
(pair fail) is displayed and the green
indicator on the subwoofer lights up.
If the wireless connection fails, set up
the connection manually.
Switch to standby mode
To switch the soundbar to standby mode:
1
Press .
The clock (if set) is displayed.
To switch the soundbar to Eco Power Standby
mode:
1
Press and hold to switch the soundbar
to Eco Power Standby mode.
The backlight on the display panel
turns off.
The blue Eco Power indicator lights up.
»
»
»
»
»
»
»
»
English
EN