Philips Micro Hi-Fi System - Manual (Page 18)

18
Install remote control
batteries
Caution
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate. •
•
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
Before pressing any function button on the remote
control, fi rst select the correct source with the remote
control instead of the main unit.
If you are not going to use the remote control for a
long time, remove the battery. •
•
Set clock
1
In the standby mode, press and hold SET
TIME/PROG to enter the clock setting
mode.
The hour digits are displayed and begin
to blink.
If the hour digits are not displayed,
press and hold
for more than 2
seconds to switch to standby mode,
then repeat step 1.
2
Press + VOL - to set the hour.
The minute digits are displayed and
begin to blink.
3
Press + VOL - to set the minute.
»
»
»
3
Connect the other end to the wall outlet.
4
Connect the power plug of the digital
wireless subwoofer to the wall outlet.
EN