Philips LX80003798 - Manual (Page 15)

15
English
ö Digital Crystal Clear (on Pr/Cr Pb/Cb Y
Progressive Scan Video Out only)
It allows you to fine-tune the following settings (Gamma,
Sharpness, Chrome Delay and DCDi) on the progressive
scan output. Use
3 4 to adjust the values of these
settings, then press OK to exit.
Gamma - allows you to adjust the intensity of the picture
non-linearly. A positive value allows you to bring out low
level detail in dark scenes, while a negative value will
emphasize contrast.
Sharpness - allows you to adjust sharpness of the picture.
Chrome Delay - is where the chrome (color) and luma
(brightness) signals are not synchronized. This allows you to
adjust the advance delay of the chrome signal to yield a
perfectly clear picture.
DCDi (New Directional Correlation Deinterlacing) -
computes and tracks the angle of edge to fill in the missing
pixel on the TV screen. Switching DCDi ON will optimize
the image quality significantly, especially during the slow
motion playback.
ö TV System (NTSC/PAL conversion)
This setting is applicable only if you used the CVBS or
Pr/Cr Pb/Cb Y jacks to connect the DVD system to a TV.
Select the color system that matches the connected TV.
You do not need to change the setting if your TV is
NTSC-compatible. The factory default setting is NTSC.
However, it will not support the PAL format DVDs and
playback of a PAL DVD is not possible.
If your TV is compatible with both NTSC and PAL,
select AUTO.
If your TV is PAL-compatible,
select PAL . It will change the video signal of a NTSC disc
and playback in PAL format.
Note:
– Slight picture distortions may occur due to this conversion.
This is normal.
P
REPARATIONS
Setting the sound
Digital output
Analog output
Night mode
Karaoke vocal
PCM output
Stereo
On
48 KHZ
All
1en 1en st 1
Speakers Settings...
Off
ö Digital output
Digital output lets you specify the type of digital output
available with the other equipment connected.
Select All, if you have connected the DVD system’s
DIGITAL OUT jack to an equipment that has a
multichannel decoder.
Select PCM only (default setting), if the other equipment is
not capable of decoding multichannel audio.
Select Off to deactivate the digital output.
Note:
– You cannot hear the SACD or MP3-CD playback if you use
the digital connection.
ö Analog output
Select Stereo, 3D sound (TruSurround) or Multi-channel
to match your DVD home cinema system’s playback
capability.
This function can also be accessed via the
SURROUND button on the remote control.
ö Night mode
Select On to level out the volume, high volume outputs will
be softened. For example, the disc will play at the same
sound level throughout the movie.
ö Karaoke vocal (not functional for this model)