Philips LX80003798 - Manual (Page 13)

13
English
Inserting batteries into the
remote control
1 Open the battery compartment.
2 Place the batteries in the
compartment with the correct
polarity as indicated by “+“ and “-“
symbols.
3 Close the cover.
CAUTION!
– Remove batteries if they are exhausted or will
not be used for a long time.
– Do not use old and new or different types of
batteries in combination.
– Batteries contain chemical substances, so they
should be disposed off properly.
Switching on the system
1 After completing all the connections, connect the AC
power cord of the DVD system and subwoofer to the
power outlet.
● The first time you turn on power,
"
AUTO INSTALL - PRESS PLAY" may appear on the
display screen. PressÉÅ on the system to star t
installation or press Ç to exit (refer to “Radio Reception -
Plug and Play”).
2 Press SOURCE button (or press TV/AV, DISC, TUNER
or AUX/DI) to select the input source.
➜ The selected source will be displayed.
● For viewing a DVD or VCD, a TV needs to be connected
(refer to “Connections - Connecting a TV”).
Switch on the TV and set it to the correct video in channel
(for example, EXT1, EXT2, AV1, AV2). Refer to your TV
instruction manual for details.
➜ The default screen appears on the TV.
● You can connect other equipment to the DVD system in
order to use the Home Cinema Audio System’s surround
sound capabilities. For example, connect to a TV and select
TV/AV as the input source or connect to a VCR and select
AUX as the input source.
IMPORTANT!
– If your TV screen is only showing a black/white
picture or the picture is completely distorted,
please refer to “NTSC/PAL setting” or “System
Setup (DVD) - TV system”.
– If you do not get a proper picture or sound,
please refer to “System Setup (DVD)” in order to
change the pre-settings as necessary to
accommodate your TV system or change to your
preferred settings.
NTSC/PAL setting
Set the DVD system to NTSC or PAL, whichever matches
your TV. The factory default setting is NTSC.
This setting
is necessary if you connected the DVD system to a
PAL TV only.
1 Press SOURCE or DISC
to select disc mode.
➜ Make sure that no disc
is inside the disc tray.
2 Hold down DISC on the
remote control until the
current setting (NTSC or
PAL) appear on the display.
3 If you want to change the setting, repeat step 2.
P
REPARATIONS
☞