Philips LX80003798 - Manual (Page 10)

10
English
Connecting the speakers
Connect the supplied speaker systems using the supplied
speaker cables by matching the colors of the jacks and
speaker cables.
1 Press up (or down) the clip on the speaker’s jack and fully
insert the stripped portion of the speaker cable into the
jack, then release the clip.
8 mm
a b c
2 Connect the subwoofer’s AUDIO INPUT jack to the
WOOFER LINE OUT jack and then connect the
speakers as follows :
Speakers - +
Front Right (R) (FR) black red
Front Left (L) (FL) black white
Center (C) black green
Surround Right (SR) black gray
Surround Left (SL) black blue
Before connecting the speakers;
● Set up the speaker stands
(refer to the accompanying
“Installation Guide”) or/and
mount the speakers onto the
mini speaker stands as shown in
the illustration.
● Remove the protective cover
only after the connection and
installation of speakers are
completed.
Notes:
– Ensure that the speaker cables are correctly connected.
Improper connections may damage the system due to short-
circuit.
– For optimal sound performance, use the supplied speakers.
– Do not connect more than one speaker to any one pair of
+/- speaker jacks.
– Do not connect speakers with impedance lower than the
speakers supplied. Please refer to the SPECIFICATIONS
section of this manual.
C
ONNECTIONS
Connecting a TV
You must connect a TV to the DVD system in order to use
the DVD player.
To listen to the TV broadcast channels
through the home cinema sound system
● Use the supplied audio cables to connect the system’s
AUDIO- TV IN (L/R) jacks to the corresponding
AUDIO OUT jacks on the TV.
IMPORTANT!
There are various ways to connect the system to a
TV (as shown in the illustration below). You only
need to make ONE of the best connections,
depending on the capabilities of your TV system.
If your TV has a S-video input connector
● Use the S-video cable to connect the system’s
S-VIDEO jack to the S-Video input jack on the TV.
If your TV has a component video
(Pr/Cr Pb/Cb Y) input connector
1 Use the Pr/Cr Pb/Cb Y cables to connect the system’s
Pr/Cr Pb/Cb Y jacks to the corresponding
Pr/Cr Pb/Cb Y In jacks on the TV.
2 for model LX8000SA only - If your TV can accept
progressive signals, move the P-SCAN switch (located
at rear panel) to “ON”.
Note:
– The progressive scan video quality is only possible through
Pr/Cr Pb/Cb Y output.
If your TV is not equipped with Pr/Cr Pb/Cb Y
or S-Video input connector
● Use the video cable to connect the system’s CVBS jack to
the video input jack on the TV.
Note: On the TV,
– The S-Video In jack may be labeled Y/C, S-Video or S-VHS.
– The CVBS jack is usually yellow and might be labeled
Video In, Composite or Baseband.
+ +
AM
FM/AM ANTENNA
FM 75 Ω
S-VIDEO
CVBS
VIDEO OUT
AUDIO
AUX
IN
TV
IN
LINE
OUT DIGITAL
OUT
CENTER
OUT
DIGITAL
IN
WOOFER
LINE OUT
Pr/Cr
Pb/Cb
Y
P-SCAN
ON OFF
CDR
Pr/Cr
Pb/Cb
Y