Philips 10002865 - Manual (Page 9)

7
4 5
1 3
6
7 8 9
2
Insert the fi lter in the empty tank.
The reference mark and the
groove must match. Push fi rmly
until it is completely inserted.
Select “fi lter” and press
again.
When the machine has fi nished, turn the knob until it is in the rest position ( ). Press a few times until the
“exit” message is displayed. Then press . The machine is now ready for use. NOTE: if the Intenza water fi lter
is not used, insert the small white fi lter previously removed (see step 1) into the water tank.
Place a container beneath the hot
water/steam spout.
Press .
Select “maintenance” and press the
button.
Select “activate” and press the
button.
Turn the knob to the position.
Water dispensing begins.
3 maintenance
3.1 filter 3.1.3 activate
execute now
Remove the small white fi lter from
the water tank and store it in a dry
place sheltered from dust.
INTENZA WATER FILTER
To improve the quality of the water you use, and to extend the life of your machine at the same time, it is
recommended that you install the water fi lter. After installation, select the water fi lter function under the
maintenance menu (see page 21). By setting the water fi lter status to ON, the machine informs the user when
the fi lter must be replaced.
Remove the water fi lter from its packaging, immerse it vertically (with the opening facing upwards) in
cold water and gently press its sides so as to let the air bubbles out.
Fill the water tank with fresh
drinking water and re-insert it into
the machine.
Set the Intenza Aroma System:
A = Soft water
B = Medium water (standard)
C = Hard water
2.
3.
1. 1.
2. 2.
1.