beautypg.com

Checking for gas leaks, Operating instructions, Air shutter adjustment – Broilmaster P4 User Manual

Page 17: Peration, Ropane, Atural, Rills operating instructions, Using the igniter, Using matches

background image

P3, P4

Page 17

Checking for Gas Leaks

Check for gas leaks every time you connect
your Broilmaster

®

propane gas grill to a Propane

gas cylinder, when a connected cylinder has not
been used recently, or when either a natural or
propane grill is being used for the first time.

C

AUTION

: D

O

NOT

USE

AN

OPEN

FLAME

WHEN

CHECKING

FOR

LEAKS

. C

HECKING

FOR

LEAKS

WITH

AN

OPEN

FLAME

MAY

LEAD

TO

A

FIRE

OR

EXPLOSION

,

RESULTING

IN

PROPERTY

DAMAGE

OR

PERSONAL

INJURY

.

To check for gas leaks:

1. Use dish washing liquid and a little water to

make a soapy solution.

2. Turn OFF the knob on the control panel.

3. Turn ON the gas at the supply or cylinder. A

hissing sound indicates a leak. Turn OFF the
gas and repair the leak.

4. Apply the soapy water solution to all gas

connections.

5. Look for bubbles. Bubbles indicate a leak.

6. If there are bubbles turn OFF the gas and repair

the leak.

7. Turn the gas back ON and repeat the above

procedures until all leaks are repaired.

Operating Instructions

Using the Igniter

C

AUTION

: I

F

A

BURNER

FAILS

TO

LIGHT

AFTER

5

SECONDS

,

TURN

THE

BURNER

OFF

FOR

5

MINUTES

,

TO

ALLOW

THE

GAS

TO

CLEAR

,

THEN

TRY

AGAIN

.

1. Turn knob on the grill CLOCKWISE to the

OFF position.

2. Turn ON gas at the source.

3. With the grill lid open, push and turn the burner

control knob COUNTERCLOCKWISE to Hi.

4. Push and hold the igniter button until the

burner lights (approximately 5 seconds).

5. If a burner does not light, turn OFF all gas

and refer to the Troubleshooting section of
this manual.

Air Shutter Adjustment

The venturi air shutter(s) are preset at the
factory so that after five minutes the burner
flames are blue with well defined cones. If, after
five minutes the flame is yellow, or there is a gap
between the burner and the flame, adjust the
venturi air shutter as follows:

1. Turn gas OFF and let the burner cool.

2. Loosen shutter set screw

3. Close the air shutter to the minimum opening.

Refer to Figure 11.

4. Light the burner, wait five minutes and then

carefully open the air shutter until the flame is
blue and well defined.

5. Retighten the set screw.

O

PERATION -

P

ROPANE &

N

ATURAL

G

RILLS

Operating Instructions

Using Matches

C

AUTION

: I

F

A

BURNER

FAILS

TO

LIGHT

AFTER

5

SECONDS

,

TURN

THE

BURNER

OFF

FOR

5

MINUTES

,

TO

ALLOW

THE

GAS

TO

CLEAR

,

THEN

TRY

AGAIN

.

1. Turn knob on the grill CLOCKWISE to the

OFF position.

2. Turn ON gas at the source.

3. Open the grill lid.

4. Insert a burning long wooden match through

the lighter hole on either side of the grill.

5. Turn the burner control knob

COUNTERCLOCKWISE to HI.

6. If a burner does not light, turn OFF all gas

and refer to the Troubleshooting section of
this manual. F

IGURE

23.

F

IGURE

23