Philips HTS5800H-37 - Manual (Page 92)

8239 300 30571
Step 1: Inserting batteries into
the remote control
1
3
2
1
Open the battery compartment.
2
Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
3
Close the cover.
Using the remote control to operate
the system
1
Aim the remote
control directly at the
remote sensor (iR) on
the front panel.
2
Select the source you
wish to control by
pressing one of the
source select buttons
on the remote control
(for example TV,
TUNER).
3
Then select the
desired function (for
example
S, T ).
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.
Getting Started
SOUND
TV DISC TUNER AUX
DVD MENU
DISC
SYSTEM
VOL
PLAY/PAUSE STOP RESUME
REPEAT REPEAT SLEEP DIM
SURROUND SOUND NIGHT MUTE
M ™ AUX ™
Step 3: Setting the speakers
You can adjust the delay times (center
and rear only) and volume level for
individual speakers. These adjustments let
you optimise the sound according to your
surroundings and setup.
IMPORTANT!
Press SURROUND button on the
remote to select Multi-channel
(DOLBY DIGITAL / DTS / MOVIE /
MUSIC / PRO LOGIC) surround
mode before adjusting the speaker
settings.
1
In active mode, press and hold PROG for
five seconds to enter system setup.
2
Press
S / T on the set to select
one of the following options :
CENTER
DELAY, REAR DELAY, TEST TONE or
MENU OFF.
001-003_HTR5000_01_Eng3 10/3/05, 2:30 PM 14
Step 2: Switching on/off
After completing all the connections,
connect the AC power cord of the AV
receiver to the wall outlet.
Switching to an active mode
●
Press the SOURCE control to select :
DISC 6CH ™ DISC COAX ™
DISC OPTI ™ FM ™
TV ™ DISC 6CH ....
OR
Press TV, DISC, TUNER or AUX on
the remote.
Switching to standby mode
●
Press STANDBY ON (B).
➜
The display screen will go blank.
A
English
17