Philips DVDR3505-37 - Manual (Page 24)

24 EN 24 EN
CHANNEL SETTING
If you have changed antenna connection, we recommend that you program available channels in your area with the
following procedures.
1 Press [SETUP] and use [K / L] to
select “General Setting”, then press
[OK].
“General Setting” menu will appear.
2 Use [K / L] to select “Channel”, then
press [OK].
“Channel” menu will appear.
3 Use [K / L] to select “Auto Channel
Preset”, then press [OK].
4 Use [K / L] to select the type of
broadcasting signal, then press [OK].
General Setting
Playback
Display
Video
Recording
Clock
Channel
DivX
HDMI
Reset All
Auto Channel Preset
Manual Channel Preset
TV Audio Select
Auto Channel Preset
Antenna
Cable (Analog)
Cable (Analog / Digital)
The unit will start getting channels available in
your area.
• When aerial antenna is connected, select
“Antenna”.
• When connected to CATV, select “Cable
(Analog)” or “Cable (Analog/Digital)”.
To cancel the auto channel preset during
scanning:
Press [BACK
] or [SETUP] to cancel.
5 When scanning is over, press [SETUP]
to exit.
To cycle through only the memorized channels, use
[CH
/ ].
To select a channel directly (including the ones not
memorized), use [the Number buttons].
Auto Channel Scan
Note
• If the auto channel preset is canceled during
presetting, some channels not yet preset may not be
received.
E7H40UD_EN_v5.indd 24 E7H40UD_EN_v5.indd 24 2008/06/02 14:49:37 2008/06/02 14:49:37