Philips DVDR3505-37 - Manual (Page 14)

14 EN 14 EN
RF MODULATOR CONNECTION
rear of this unit
rear of your TV
rear of your RF modulator
(not supplied)
IN
IN OUT OUT
VIDEO OUT Y
P R /C R
P B /C B
R
L
R
L
VIDEO IN
S-VIDEO S-VIDEO ANTENNA
COAXIAL
HDMI OUT
AV IN AV OUT COMPONENT VIDEO OUTPUT DIGITAL AUDIO OUTPUT PCM / BITSTREAM
RCA audio cable
RCA video
cable
AUDIO IN TO TV ANT. IN
L R
CHANNEL
4 3
VIDEO IN
IN
OUT
ANTENNA
ANT. IN
Set channel 3 or 4
VIDEO
OUT
R
L
AV OUT
RF coaxial cable
RF coaxial cable
VHF / UHF
antenna
RF coaxial cable
cable TV
company
or
If your TV has antenna in jack only, it is still possible to connect this unit to your TV by using a commercially available
stereo audio/video RF modulator. In this case, follow the instructions below.
1) Disconnect the power cords of the devices from the AC outlet.
2) Make the connection as illustrated below.
3) Set your RF modulator’s channel 3/4 switch to either 3 or 4, whichever the TV channel is least used in your area.
If your RF modulator has a modulator/antenna switch, set it according to the manual supplied with the RF
modulator.
4) Plug in the power cords of the devices to the AC outlet.
5) Turn on your TV and choose the same channel as you set the RF modulator’s channel 3/4 switch to.
For more details, follow the manual supplied with the RF modulator.
Note
• RF modulator is not supplied with this unit. You need to purchase it at your local store.
• The quality of picture may become poor if this unit is connected to an RF modulator.
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
E7H40UD_EN_v5.indd 14 E7H40UD_EN_v5.indd 14 2008/06/02 14:49:32 2008/06/02 14:49:32