Philips 151AX - Manual (Page 19)

19
E
N
OSD OSD
W W arning Signal arning Signal
Additional Information
The monitor will detect various display situation automatically. When the monitor detects the problems, the screen will automatically show the
different warning signals to remind you. This warning signals can be disabled by pressing AUTO button for more than 10 seconds if there is no
video signal in.
• NO VIDEO INPUT •
This screen appears when there is no video signal input. Please check
that the signal cable is properly connected to the graphics board or
PC.
• CANNOT DISPLAY THIS VIDEO MODE •
This screen appears when the input frequency from the computer is
not standard video mode or out of the monitor’s scanning range.
Please change the display mode of the operating software in the
computer (i.e. Windows) to1024 x 768 @ 60 Hz for best display
results.
• ENTERING SLEEP MODE •
This screen warns when the monitor is about to enter the sleep mode.
Please press any key on the keyboard or click the mouse for waking
the monitor and computer.
• MONITOR TEMPERATURE TOO HIGH •
This screen apppears for 5 seconds of every 3 minutes , when panel
temperature is self-detected to be over 50°C. Please turn off the
power switch immediately and check the room temperature if too hot.
Don’t install LCD monitor under direct sunlight or at high room
temperature.
NO VIDEO INPUT
CANNOT DISPLAY THIS VIDEO MODE
ENTERING SLEEP MODE
MONITOR TEMPERATURE TOO HIGH