Philips BDH5011-74 - Manual (Page 23)

23
User Manual BDH5011
8.2 Selecting Signal Source
Using Front Panel or Remote Control
1. Press the INPUT button on the front panel
or the INPUT SELECT button on the
remote control.
2. Pressing the INPUT button will cycle the
display through all available input signal
sources in the following order:
Using Direct Input Selection Buttons
1. If you prefer not to cycle through all
available inputs, you can use the Direct Input
Selection buttons located at the bottom of
the remote control.
2. Simply select the input that you would like
to switch to and press the Direct Input
Selection button for that input.
Notes:
• Some of the Direct Input Selection buttons
will not be applicable for this display.
For AV mode, use AV1.
For S-Video, use AV2.
AV S-VIDEO COMPONENT1
RGB COMPONENT2 DVI
DIRECT INPUT
SELECTING KEYS
INPUT SELECT
(Toggle)