Philips widescreen flat TV 50PF9956 127 cm 50" plasma Progressive Scan - Manual (Page 26)

22
Your remote control is set to work your TV and many infrared remote (IR) control VCRs, Cable TV
Converter Boxes, DVD players, Satellite Receivers, etc.
Press the
Select button repeatedly to select DVD/R , CBL , VCR or AUX according to the accessory
device you want to operate with this remote control. See Use of the Remote control, p. 3. Press the
POWER button.
If the function buttons on the remote control also work the selected accessory device, then the remote is
ready and no further steps are needed.
If the function buttons do not work with the selected accessory device, according to the device(s) you
own, you may make your remote control ready for them by a direct entry code. Proceed as following.
Code setup
& Press the Select and POWER buttons at the
same time, then release.
é NOTE :When inputting the digits as described
below, you must not allow more than 20
seconds to pass between the input of each digit
or you will need to return to step 1 and begin
the programming process again.
Input the appropriate digit provided below for
the type of accessory device you want to
operate:
1 DVD/R
2 CBL (HD-STB)
3 CBL-SAT
4 VCR
5 AUX (AMP, CD).
“ Input the 4-digit code for the type and brand of
accessory device.The codes are listed on pages
23-24.
‘ The green light behind the POWER button will
blink for 3 seconds to show that a valid code
was input.
If a valid code was not entered, the light will
stay on continuously for 3 seconds. If that
occurs, go back to step 1 and begin the
programming process again.
( Now you will try to use the TV remote with
the accessory device. Press the
Select button
on the remote to cycle across the accessory
mode dial. Stop pressing the button when the
mode you desire is lighted.The light will stay on
for 2 seconds and then begin blinking.The
blinking means that the remote is in the
accessory mode you have selected.
§ Within 60 seconds from the time the blinking
starts, point the remote toward the accessory
device and press the
POWER button. If the
device does not respond to the POWER
command, follow the steps for programming
the remote again using a different setup code
for the type and brand of accessory device you
wish to operate. Refer again to the code list on
pages 23-24. If no more codes are listed for the
type and brand of accessory device, the remote
likely will not operate your particular model of
accessory device.
Notes:
- Your TV remote is not necessarily capable of being
programmed to operate all models of the brands of
accessory devices listed on pages 23-24. You may
want to try the programming process again. Try using
the number(s) that are listed for your type and brand
of device to be sure you did not make a mistake in
inputting the digits during your first attempt at
programming.
- If the remote control is in one of the accessory
modes (a mode light is flashing) — DVD/R, CBL, SAT,
VCR or AUX — and you don’t press any of the
remote buttons for sixty seconds, a “time-out” occurs,
returning the remote to TV mode.
Setting the remote control to work accessory devices