Philips widescreen flat TV 50PF9956 127 cm 50" plasma Progressive Scan - Manual (Page 10)

6
General Clock Source
TV
Settings
Demo
Install
The General menu allows you to change settings that will
typically be accessed only occasionally.
The
Clock menu allows you to use your TV as a clock.
For the correct working of On timer and lock after features,
helps you select the correct option.
The
Source menu allows you to select a source.
General
Menu background
Surf
Reset AV settings
Caption Service
OSD
Set/Change pin
Subwoofer
Settings
& Select Autoprogram in the Install menu.
é Press the cursor down to select Install mode .
“ Press the cursor right.
Note: It is recommended to keep the predefined
Automatic way of autoprogramming. In case of
difficulties in autoprogramming with the automatic
method, choose for Antenna or Cable whether
antenna or cable signals are present.
When Automatic is selected, the TV will
automatically detect whether or not cable
signal input is present.
When
Antenna is selected, the TV will detect
antenna signals and will search for all antenna
TV channels available in your local area.
When
Cable is selected, the TV will detect
cable signals and will search for all cable TV
channels available in your local area.
‘ Press the cursor down to select Install .
Note: All channels must be unlocked in order to
autoprogram. If requested, enter your PIN code to
unlock all channels. (See Channels in the TV menu,
p. 12.)
( Press the cursor right.
§ The message Searching appears and the
progress of autoprogramming is displayed.
When Autoprogramming is complete, the puck
navigates to Stop. A message appears
confirming the completion together with the
total number of channels found.
Note: when you navigate to Stop before
autoprogramming is complete, you are given the
option to continue.
Available channels:
- with cable: max. from 1 to 125
- off air: max. from 2 to 69
Note: In case a particular channel is too weak for
the autoprogramming to identify, after installation is
complete, you should tune to that channel by using
the digit buttons on the remote control.
If the channel is not acquired, a message will
appear that the channel is not available.
Autoprogram
Install mode
Install
Install
Start
Antenna
Automatic
Cable
Menu background
& Select Menu Background with the cursor down and press the
cursor right.
é Select On or Off to turn the menu background on or off.
Surf
& Select Surf .
é With the cursor left/right, select
• 2 channels if you want the SURF button to toggle between the
current and the previously selected channel,
• 9 channels if you want the SURF button to summon a list of
up to 9 channels which can be selected.
To add/remove a channel or source to the 9 channels list:
Tune to the channel or source you wish to add or remove.
Press the
SURF button and press the cursor right to add or
remove.
Note: If there are already 9 channels/sources in the list, the one at
the bottom of the list will be removed.
General
Settings menu
Store TV channels