Philips 58PFL4609-F7 - Manual (Page 37)

Network
Set up Network connection settings in order to use Net TV or Network
Upgrade function.
● The meanings of abbreviations are defined as below.
AP
: Wireless LAN Access Point
WPS : Wi-Fi protected Setup
SSID : Wireless network name
●
The key entry screen will appear when you select SSID, WEP /
WPA / WPA2 or Proxy address.
1 2 3 4 5 6 7 8 9 0
a b c d e f g h i j
k l m n o p q r s t
u v w x y z . - _
―
OK Cancel a/A/@ All clear Clear
● Enter the key of the selected wireless network using H I J K,
then press OK.
Clear
: Clear the entered number or word.
All clear : Clear all the entered numbers or words.
a/A/@ : Switch between abc, ABC and @!?
Cancel : Shows the cancellation display.
OK : Set the entered number or word.
1
Use H I to select Network, then press OK.
Reset AV settings
Network settings a
Location
Autoprogram
English
Restore default settings
Network
Preferences
Channels
Language
Software
Installation
Features
Sound
Picture
Settings assistant
Network settings assistant
Before you proceed to Connection test or other settings in Network
section, run the Network settings assistant to connect the TV to your
Network.
2
Use H I to select Network settings assistant then press OK.
Start now
Renderer
Information
Start now
Network selection
Start now
Reset network settings
Home network
Setting status
Connection test
Manual network settings
Network settings assistant
Restore default settings
Network
Preferences
Channels
Language
3
Press OK to select Start now.
Wireless setting
Select to use a wireless LAN to connect to the internet by wireless
connection.
4
Use H I to select Wireless, then press OK.
Wired
Wireless
Cancel
www.philips.com/support
downloaded from
the latest TV software can be
If not connected to the network,
Select your connection type.
home network.
This TV can be connected to your
5
Use H I to select the desired setting, then press OK, and follow
the On-screen Instructions.
Easy Connect
Select this setting if your router has a Wi-Fi
Protected Setup (WPS) button. Start scanning
for wireless networks on the TV after pressing
the WPS button on your router. If connection
test fails, try Easy Connect again. * If it fails then
refer to the router’s manual for more details.
Scan
Search for Wireless Networks automatically and
select the Wireless Network name (SSID) from
the list. Wireless network setting L p. 38
Manual
Set up the connection to the Wireless LAN
Access Point (AP) (e.g. wireless router) manually
by entering the Wireless Network name (SSID).
* WPS (Easy Connect) cannot be used when the security protocol is set
to WEP. Change the Access Point’s security mode from WEP to WPA
or WPA2 (recommended).
Wired setting
Select to use an Ethernet cable to connect to the internet by wired
connection. Please purchase shielded Ethernet cables at your local store
and use it when you connect to Network equipment.
4
Use H I to select Wired, then press OK.
●
Connection test will start automatically. L p. 40
37 .
English
Continued on next page.