Philips CD1811G-NL - Manual (Page 26)

25
Remote access
You can operate your answering machine when
you are away from home. Simply make a call to
your phone with a touch tone phone and enter
your 4-digit PIN code.
Note
The remote access PIN code is the same as •
your system PIN. The preset PIN is 0000.
Activate/deactivate the remote access
You can allow or block remote access to the
answering machine.
1
Press MENU/OK.
2
Select [ANSW MACHINE] > [REMOTE
ACC.], then press MENU/OK to confirm.
3
Select [ON]/[OFF], then press MENU/
OK to confirm.
The setting is saved. »
Change the PIN code
1
Press MENU/OK.
2
Select [ANSW MACHINE] > [REMOTE
ACC.] > [CHANGE PIN], then press
MENU/OK to confirm.
3
Enter the old PIN, then press MENU/OK
to confirm.
4
Enter the new PIN code, then press
MENU/OK to confirm.
5
Enter the new PIN code again, then press
MENU/OK to confirm.
The setting is saved. »
Access the answering machine
remotely
1
Make a call to your home number with a
touch tone phone.
2
Enter # when you hear the
announcement.
Delete an incoming message
Press on the base station when you listen to
the message.
The current message is deleted. »
Delete all old incoming messages
Press and hold on the base station in
standby mode.
All old messages are permanently »
deleted.
Set the ring delay
You can set the number of times the phone
rings before the answering machine picks up
the call.
1
Press MENU/OK.
2
Select [ANSW MACHINE] > [RING
DELAY], then press MENU/OK to
confirm.
3
Select a new setting, then press MENU/
OK to confirm.
The setting is saved. »
Note
Ensure that the answering machine is switched •
on before this feature can be applied.
Tip
When you access the answering machine •
remotely, you are recommended to set the
ring delay to [TOLL SAVER] mode. This is a
cost effective way to manage your messages.
When there are new messages, the answering
machine picks up the call after 3 rings; When
there is no messages, it picks up the call after
5 rings.
English
EN