Philips CD1811G-NL - Manual (Page 27)

26
LED display Message status
Steady on There is new message and the
memory is not full.
Flashing There is a new message and
the memory is not full.
Flashing
(Fast)
There is no new message and
the memory is full.
Flashing Recording an incoming
message/announcement.
Flashing Message playback.
Flashing Remote access/listen to
messages from the handset.
Steady on The handset is switched on.
Steady on Enter the paging mode
Flashing
(Fast)
Enter the registration mode
Flashing There is an incoming call.
3
Enter your PIN code.
You now have access to your »
answering machine, and you can now
listen to the new messages.
Note
You have 2 chances to enter the correct PIN •
code before your phone hangs up.
4
Press a key to carry out a function. See
the Remote access commands table
below for a list of available functions.
Note
When there is no message, the phone hangs •
up automatically if no key is pressed for 8
seconds.
Remote access commands
Key Function
1 Repeat the current or listen to
the previous message.
2 Listen to messages.
3 Skip to the next message.
6 Delete the current message.
7 Switch the answering machine
on.
(not available when you listen to
the messages).
8 Stop listening to the message.
9 Switch the answering machine
off.
(not available when you listen to
the messages).
Behavior of the LED display on the
base station
The table below shows you the current status
with different LED display behavior on the
base station.
EN