Bosch WFD50818 - Manual (Page 35)

33
Installation Instructions
Electrical connection
When heating, the maximum current of the washing mach-
ine is 10A, so please make suer that the power supply sys-
tem (voltage, current and cable) is applicable to the load of
the applied appliance.
The machine must only be connect to an alternating curr-
ent supply via a correctly installed earthed socket.
The voltage indicated on the rating plate at the back of the
machine must match the mains voltage at the installation
location.
Connected load and required fuse or line protecting cut-out
are indicated on the rating plate.
It must be ensured that the plug and socket match, that the
conductor cross-section is sufficient and that the earthing
system has been installed in compliance with regulations.
Multiple plug connectors and extension cables must not be
used.
Do not connect the machine to electrical outlets while your
hands are wet or damp.
To remove the plug from the socket, grasp the plug firmly
and pull it out. Do not pull at the cable.
If the supply cord is damaged, it will be replaced by a spe-
cial cord or a assembly available from the manufacturer or
its service agent.-
In the event that an earth-leakage circuit breaker is to be
used, only use types marked with the following symbol:
. Only this symbol can guarantee compliance with all
current regulations.