BT 1250 Classic - Manual (Page 14)

14
On-Air 1250 Classic user guide ~ 1st Edition ~ 7th August ’01 ~ 4073
Press the OK button.
Press the 7 button.
Use the UP and DOWN buttons to
select the base you require.
The flashing digit on the left of the
handset is the base number.
Flashing -0- indicates that no base has
priority and the handset will therefore
register to the first base it finds.
Press OK to confirm.
C OK
C OK
▲
▼
To change base station priority
Press the INTERCOM button.
Press the OK button. F1 will appear on
the display.
Press the 3 button.
Press the 1 button.
Enter existing code (0000 if not
changed). As you enter each digit in
turn the dash will stop flashing. When
you have entered four digits all four
dashes will then start flashing again.
Enter your new System Code. As you
enter each digit in turn the dash will
again stop flashing.
Enter your new System Code again.
Press the C button twice to exit.
C OK
C OK
C OK
Intercom
OLD
CODE
NEW
CODE
CONFIRM
CODE
To change your System Code
3
DEF
1
7
PQRS
System Code
Your base station has a default setting of 0000
but you may want to change this.
If you change your System Code keep a record
of the new number by writing it in the space
provided on page 4.
Base station priority
If you are using more than one base, you can
select which base your handset will use.
Base settings