Initial fill & heat – Bunn LCA-2 LP 38791.0000K User Manual
Page 10
10
INITIAL FILL & HEAT
1. Select Normal on the Function Selector Switch and Run on the Mode Selector Switch.
2. Confirm the water supply is on.
3. Connect the dispenser to the power source. The Red POWER LED will illuminate and water will begin flowing
into the tank. The dispenser will automatically stop filling when the tank is full. The dispenser will not begin
heating the water until after the tank is filled.
4. The Green READY LED will illuminate when the tank temperature reaches the preset ready temperature.
3 4
1
38791 031606
See also other documents in the category Bunn Water equipment:
- TDO-3.5 (2 pages)
- AF PR-2 (18 pages)
- TDS3 (2 pages)
- TCD (3 pages)
- ULTRA-1 (17 pages)
- ULTRA-1 (2 pages)
- TDS-5S (3 pages)
- EASY CLEAR H5E (2 pages)
- AFPO-2 SL (25 pages)
- EASY CLEAR EQ-12-TH (2 pages)
- WATER QUALITY SYSTEM EQHP-25L (2 pages)
- EASY CLEAR EQ-17-TL (2 pages)
- HW2 (4 pages)
- LCA-2 (22 pages)
- HW2A (4 pages)
- ULTRA-2 (23 pages)
- FMD-2 (2 pages)
- SILVER SERIES JDF-2S (28 pages)
- FCD-4 (21 pages)
- EASY CLEAR EQHP-ESP (2 pages)
- FMDS-3 (2 pages)
- TDO-N-4.0LP (2 pages)
- ULTRA-2 PAFA (4 pages)
- JDF-2 (21 pages)
- LCR-2C (2 pages)
- TCD-2 (18 pages)
- FMD DBC-3 4-CUP (4 pages)
- LCR-3 (27 pages)
- EQHP-10L (2 pages)
- 2 (3 pages)
- Water Quality System EQHP-35L (2 pages)
- Chilled LCC-2 (26 pages)
- TDO-4T TDO-5 (2 pages)
- ICD3 (3 pages)
- Water Quality System EQHP-TWIN 108SP (2 pages)
- TCD-1 (2 pages)
- TDO-N (2 pages)
- FMD-5 (45 pages)
- JDF-4S (2 pages)
- JDF-2S (28 pages)
- AFPO-3 SL (25 pages)
- Complete Store Water Quality Systems EQHP-TWIN 70L (2 pages)
- EDSS-11-T200F (2 pages)
- TDO-N-3.5 (2 pages)