Brother 1300 - Manual (Page 6)

Foot 4
rrow
ee settings based
n fabric and whether the pin feed is used. Presser
ength are
adjusted to produce a balanced stitch.
als Needed for Sample:
Quilting cotton, upholstery cord
wing Directions:
iece, wrapping the cord completely, for a very tight fit. Sew between
the cords. When through, trim off excess fabric close to stitching line. Apply cord to your project with the
trimmed edge underneath.
Very Na
SA172
Optional PQ foot for sewing on lightweight and
fine fabric, sewing in very tight areas or attaching
zippers
Machine Set-Up:
Feed dogs up using one of the thr
o
foot dial, thread tension and stitch l
normally
Materi
General Se
Follow normal sewing instructions.
Specific PQ Sample Directions:
For double welting, cut fabric wider than three times
width of double cord. Sample uses two-inch strip cut on
straight of grain. Lay cords ½” from the edge of fabric. Fold the ½” section over the double cord, covering
the full width. Fold over the entire p
Feed
Dogs Presser
Foot Dial Thread
Tension Stitch
Length
Midweight +/- 4 3
Brother PQ-Accessories Workbook July 2003 62