Brother 1300 - Manual (Page 13)

Foot 11
Walking
XA7253-001
The walking foot holds the fabric between the
presser foot, upper and lower feed dogs to better
control difficult fabrics. It is standard on the PQ.
Machine Set-Up:
Feed dogs up using one of two settings based on
fabric. Adjust other settings for the fabric used. Pin
feed is not used with this foot.
Materials Needed for Sample:
Cotton fabric, thin batting
General Sewing Directions:
While normal sewing techniques are used with this
foot, it is important to not sew more than 70 per
cent of maximum speed to allow the foot to work
evenly. Test the presser foot settings to make sure it is not too strong as that will influence foot movement
s well.
was sandwiched with thin batting and backing and stitched together with the walking foot.
Dogs n
a
Feed Presser
Foot Dial Thread
Tensio Stitch
Length
Midweight +/- 4 2.5 to 3
Specific PQ Sample Directions:
Squares 1 ½” each were sewn together in a
checkerboard fashion with the ¼” foot. The pressed top
Brother PQ-Accessories Workbook July 2003 69