Aironet Lan Adapter - Manual (Page 62)

Installing the Software
3-22
Additional system performance adjustments can be made
with the following group of variables.
Table 3.9 - Scanning Keywords
Keywords Value Description
SCANMODE ACTIVE,
PASSIVE,
ADVANCED Optional – parameter to determine
the current scanning mode to be
used by the PC Card (default is
ACTIVE).
BEACONLISTENTO 0 – 0xFFFF Optional – for passive scanning
mode, determines the amount of
time (K
µ
sec) to listen for a beacon
on each channel (default is 40
K
µ
sec).
PROBEENERGYTO 0 – 0xFFFF Optional – for active scanning mode,
determines the amount of time to lis-
ten for RF energy following a probe
(default is 3 K
µ
sec).
PROBERESPONSETO 0 – 0xFFFF Optional – for active scanning mode,
determines the amount of time to
wait for a probe response after
energy is detected on a channel
(default is 20 K
µ sec).
STATIONARY ON, OFF,
YES, NO Optional – indicates whether or not
the station is mobile (default is
OFF).
PROBEDELAY 0 – 0xFFFF Optional – indicates how long to wait
on a frequency before sending a
probe request (default is 3 K
µ sec).
OFFSCANINTERVAL 0 – 0xFFFF Optional – how often to attempt to
use the “off line” scanning method to
search for new Access Points
(default is 0 which disables off line
scanning).
OFFSCANDURATION 0 – 0xFFFF Optional – how long to use the “off
line” scanning method during each
attempt (default is 0 which disables
off line scanning).