Bogen GOLD SEAL SERIES AMPLIFIERS GS-35 - Manual (Page 7)

Panel Descriptions
Rear Panel (GS35, GS60, GS100 & GS150)
1. Amplifier Output - Terminal strip containing all the Gold Seal speaker outputs.
2. WMT1A - RCA connection for Bogen model WMT1A 600-ohm balanced line-matching transformer.
3. TO PWR AMP - RCA connection provides a high impedance, unbalanced signal level output as a feed to high
impedance inputs of other external amplifiers.
4. VAR MUTE - 4 Switch selectable levels of AUX input signal muting during TEL page (works only in the TEL input mode).
5. LO CUT FILTER - Enables or disables low frequency roll off (65 Hz) for all microphone inputs.
6. MIC 6/AUX 1 - Switch selects either MIC 6 or AUX 1 connections as input.
7. MIC 6 - Screw terminals for balanced microphone (active only when AUX 1/MIC 6 switch is set to MIC 6).
8. MIC 5/TEL - Dual-function screw terminals for either balanced microphone or 600-ohm balanced input from
telephone page port.
9. MIC 5/TEL - Switch selects mode of operation for MIC 5/TEL input.
10. REMOTE MSTR - Screw terminal pair for connection of remote master volume control (Bogen model GSRVC).
11. MIC/AUX/TEL PRECEDENCE - Screw terminal connections that allow externally controlled muting of
individual inputs.
12. POWER IN - RCA unbalanced direct input to power amp stage for connection to external signal processing
equipment (used in conjunction with PRE OUT and LINK switch).
13. PRE OUT - RCA unbalanced output from preamp/mixer stage for connection to external signal processing
equipment (used in conjunction with POWER IN and LINK switch).
14. LINK - Switch that makes or breaks the internal connection between preamp/mixer stage and power amp stage when
used with external signal processing equipment.
15. TAPE OUT - RCA unbalanced output, pre-EQ and master volume. (Post Lo-Cut filter, see #5).
10 11
1 2 3 4 5 6 7 8 9
12
13
14
15
16
17
18
19
20 21 22
7