Bosch 400 Series XPR - Manual (Page 6)

6
SPECIFICATIONS
General Specifications
Voltage Rating . . . . . . . . . .120 V, 50-60 Hz
Amperage Rating . . . . . . . . . . . . . . . . .2.0 A
No Load Speed . . . . . . . . . .No 35,000/min
Collet Capacity . . . .1/32", 1/16", 3/32", 1/8"
Motor Specifications
This Rotary Tool utilizes a variable high-
speed RPM motor. It is wired for operation on
110-120 volts, 50-60 Hz. alternating current.
Before connecting the motor cord to wall out-
let, make certain the power switch is in the
OFF position and be sure the electric current
is of the same characteristics as stamped on
the Rotary Tool nameplate.
Connection To A Power Source
To avoid electric shock,
do not touch the metal
prongs on the plug when installing or
removing the plug to or from the outlet.
If power cord is worn, cut
or damaged in any way,
have it replaced immediately to avoid
shock or fire hazard.
DANGER
!
DANGER
!
Extension Cords
If an extension cord is necessary, a cord
with adequate size conductors that is
capable of carrying the current necessary
for your tool must be used. This will pre-
vent excessive voltage drop, loss of power or
overheating.
RECOMMENDED SIZES
OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
NOTE: The smaller the gauge number, the
heavier the cord.
Tool’s
Ampere
Rating
Cord Size in A.W.G. Wire Sizes in mm2
2-6
6-8
8-10
10-12
12-16
18 16 16 14 .75 .75 1.5 2.5
18 16 14 12 .75 1.0 2.5 4.0
18 16 14 12 .75 1.0 2.5 4.0
16 16 14 12 1.0 2.5 4.0 —
14 12 — — — — — —
25 50 100 150 15 30 60 120
Cord Length in Feet Cord Length in Meters