Breckwell P22FSL - Manual (Page 21)

CHIMNEY CLEANING
a. Creosote Formation – When any wood is burned slowly, it produces tar and other organic vapors, which
combine with expelled moisture to form creosote. The creosote vapors condense in the relatively cool
chimney flue or a newly started fire or from a slow-burning fire. As a result, creosote residue accumulates on
the flue lining. When ignited, this creosote makes an extremely hot fire, which may damage the chimney or
even destroy the house. Despite their high efficiency, pellet stoves can accumulate creosote under certain
conditions.
b. Fly Ash – This accumulates in the horizontal portion of an exhaust run. Though noncombustible, it may
impede the normal exhaust flow. It should therefore be periodically removed.
c. Inspection and Removal – The chimney connector and chimney should be inspected annually or per ton to
determine if a creosote or fly ash build-up has occurred. If creosote has accumulated, it should be removed
to reduce the risk of a chimney fire. Inspect the system at the stove connection and at the chimney top.
Cooler surfaces tend to build creosote deposits quicker, so it is important to check the chimney from the top
as well as from the bottom.
The creosote should be removed with a brush specifically designed for the type of chimney in use. A qualified
chimney sweep can perform this service. It is also recommended that before each heating season the entire
system be professionally inspected, cleaned and, if necessary, repaired.
To clean the chimney, detach the vent at the combustion blower transition where it is attached to the blower.
RECOMMENDED MAINTENANCE SCHEDULE
Use this as a guide under average-use conditions.
Daily Weekly Annually or per Ton
Burn Pot Stirred Emptied
Glass Wiped Cleaned
Combustion Chamber Brushed
Ashes Emptied
Interior Chambers Vacuumed
Heat Exchange Tubes Two passes
Combustion Blower Blades Vacuumed / Brushed
Convection Blower Impeller Vacuumed / Brushed
Vent System Cleaned
Gaskets Inspected
Hopper (end of season) Emptied and vacuumed
Gasket around door and door glass should be inspected and repaired or replaced when necessary.
(See “REPLACEMENT PARTS”)
REMOVAL AND REPLACEMENT OF BROKEN DOOR GLASS
While wearing leather gloves (or any other gloves suitable for handling broken glass), carefully remove any
loose pieces of glass from the doorframe. Dispose of all broken glass properly. Return the damaged door to
your Breckwell Dealer for repair or replacement.
Neither the appliance owner nor any other unauthorized person(s) should replace the door glass. An authorized
Breckwell dealer must perform all repairs involving door glass.
MAINTENANCE 21